Code
619
Description
Pliocem is a transparent based on styrene acrylic resins with silicone
modification, which makes the surface water-repellent, and highly resistant
to chemical and atmospheric agents
modification, which makes the surface water-repellent, and highly resistant
to chemical and atmospheric agents
Use
The product is used as a transparent finish where good chemical and
abrasion resistance are required. It can be used as an anti-dust for
concrete.
abrasion resistance are required. It can be used as an anti-dust for
concrete.
Appearance of the film
Semigloss
Colour
Opalescent transparent
Component
1
Hardening
Physical by evaporation of solvents
Specific weight
0,980 gr/ml
Volume of solids
27 %
VOC
620 gr/ liter
Minimum thickness
60 -80 micron
Estimated yield
4,5 m² /L for a thickness of 60 microns dry.
Flash point
Component A 34°C
Thinner 34°C
Thinner 34°C
Temperature resistance
Max 110°C continuous 200°C discontinuous
Preparation of surfaces
New metal surfaces:
Remove from the surface dust and contaminants such as fats and oils.
New wood:
Apply a first diluted coat, remove wood hair by abrasion and give a second
coat.
New concrete:
Adequate dedusting: application of a diluted coat followed after
RESINA COLOR TECHNICAL DATA SHEET
24 hours by another alike coat or slightly diluted.
Remove from the surface dust and contaminants such as fats and oils.
New wood:
Apply a first diluted coat, remove wood hair by abrasion and give a second
coat.
New concrete:
Adequate dedusting: application of a diluted coat followed after
RESINA COLOR TECHNICAL DATA SHEET
24 hours by another alike coat or slightly diluted.
Preparation of the product
Mix the product before use and add the thinner
Component A 100
Thinner: white spirit 60% -80% (first coat)
10% - 20% (second coat)
Component A 100
Thinner: white spirit 60% -80% (first coat)
10% - 20% (second coat)
Environmental conditions
Ambient temperature: from + 5 to 40°C
Temperature of the surface: > 10°C
Humidity : 0 – 85 %
To prevent the formation of condensation the temperature of the surface
must be at least 3°C higher than the dew point
Temperature of the surface: > 10°C
Humidity : 0 – 85 %
To prevent the formation of condensation the temperature of the surface
must be at least 3°C higher than the dew point
Drying and hardening time
Frt thicknesses of 20 microns 10°C 20°C 30°C
Dry to touch 6 3 2 hours
Dry in depth 48 24 10
Dry to touch 6 3 2 hours
Dry in depth 48 24 10
Time of overpainting
Minimo (hours) 10°C 20°C 30°C
24 12 6
Maximum Unlimited, except for the presence of contaminants on the
surface
24 12 6
Maximum Unlimited, except for the presence of contaminants on the
surface
Application
Brush, roller spray
For brush applications use nylon or pure bristle brushes.
For roller applications use medium pile rollers.
For the application use the method of the crossed hands
For brush applications use nylon or pure bristle brushes.
For roller applications use medium pile rollers.
For the application use the method of the crossed hands
Shelf life
2 years in a cool and dry place (max 40°C)
Packs
Comp A Lt. 1, 5, 25. Thinner 5, 25, lt.