Elastic fibre-reinforced filler primer based on modified acrylic resins that give the product after complete drying a permanent elasticity.
Use
As intermediate filling layer on new of restored old plasters, concrete or crazed surfaces as long as well bonded. If the cracks are widespread, we recommend the use of a fiberglass mesh.
Appearance of the film
matt
Colour
White and from colour chart
Component
1
Hardening
Physical hardening by evaporation of water and coalescence of the polymer.
Specific weight
From 1,380 gr/ml
Volume of solids
51 %
VOC
120 gr/ liter
minimum
200 micron
Estimated yield
1,000 kg/mq.
Flash point
Component A > 114°C
Elongation%
200 to a thickness of 500 microns dry
washability
> 10000 touches
Preparation of the surfaces
New surfaces: remove dirt and efflorescence. Old surfaces: Make sure the old plaster is well bound and in the case of cracks wider than 1mm open them and seal with special cement sealant and then treat the surface with our underlay.
Preparation of the product
Stir well before using. For trowel applications, the product must not be diluted.
Environmental conditions
Room temperature: from + 5 to + 40°C Surface temperature: > 10°C Humidity: 0 – 85 % To prevent the formation of condensation is necessary that the temperature of the substrate is at least 3 ° C above the dew point.
Drying and hardening time
For thickness of 200 microns 10°C 20°C 30°C Dry to the touch 24 6 1 hours Through drying 24 8 2
Time of overpainting
Minimum (h) 10°C 20°C 30°C 24 8 3 Maximum unlimited in the absence of contaminants