TENNIS W
Waterproof barrier
Highly walkable and resistant to the abrasion
Resistant to water stagnation
Description
Elastic finish based on acrylic - styrene emulsions with internal plasticization.
Use
This product is suitable for the painting of concrete or asphalt tennis courts, bicycle paths or athletics tracks. When it is completely dried, it forms an elastic mantle that is resistant to the weather and to the abrasion.
Appearance of the film
Matt
Color
Green - Red
Component
1
Hardening
Physical hardening through evaporation of water and union of the polymer
Specific weight
From 1,320 – 1,380 gr/ml
Volume of solids
58%
VOC
120 gr/ liter
Minimum thickness
500 micron
Estimated yield
1,1 m² / litre for a thickness of 500 microns
Flash point
Component A > 114°C
Elongation %
50 % for a dry thickness of 2000 microns
Preparation of surfaces
Carry out an accurate cleaning by removing dust, all parts that are peeling off, grease and other contaminants. On substrates with old paints, prime with a coat of the product diluted to 30 %. On new substrates, primer with a coat of the product diluted to 40 %. Then apply a second coat diluted to 5 - 10 %.
The substrate must be dry; the presence of excessive humidity inside the substrate, during solar irradiation, can generate the formation of bubbles and the subsequent detachment of the coating.
The substrate must be dry; the presence of excessive humidity inside the substrate, during solar irradiation, can generate the formation of bubbles and the subsequent detachment of the coating.
Preparation of the product
Mix the product before the use.
For applications with a spatula, the product should not be diluted. Prime with a coat diluted with water to 40 %.
For applications with a roller, dilute the product with maximum 5 % of water.
For applications with a spatula, the product should not be diluted. Prime with a coat diluted with water to 40 %.
For applications with a roller, dilute the product with maximum 5 % of water.
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 500 microns 10° C 20° C 30° C
Dry to touch 24 6 1 hours
Dry in depth 24 8 2 hours
Dry to touch 24 6 1 hours
Dry in depth 24 8 2 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
24 8 3 hours
Maximum unlimited in the absence of contaminants
24 8 3 hours
Maximum unlimited in the absence of contaminants
Application
Spatula, roller.
If you use a roller, you have to use medium - haired or alveolar rollers.
If you use a roller, you have to use medium - haired or alveolar rollers.
Shelf life
1 year in a cool and dry place (max 40° C)
Packs
Comp A